Section 6 – MOH
QUESTION 1
Refer to the exhibit.
Which statement about the configuration between the Default and BK regions is true?
A. Calls between the two regions can use either 64 kbps or 8 kbps.
B. Calls between the two regions can use only the G 729 codec
C. Only 64 kbps will be used between the two regions because the link is "lossy"
D. Bothcodecs can be used depending on the loss statistics of the link, when lossy conditions are high, the G.711 codec will be used.
Answer: B
Explanation:
Ok. The matrix between Default and BR supports g.729 only.
QUESTION 2
Refer to the exhibit.
To stream multicast MOH to the remote site across the WAN, what should the minimum value for the Max Hops be configured as?
A. 1
B. 2
C. 3
D. 4
Answer: B
Explanation:
Ok, see 1-46 CIPT2 V8.0, multicast MOH from Branch Router Flash Example is not applicable (answer Max Hops = 1) because the question asks the stream multicast across the wan, so TTL 2.
Note the MOH server configuration is not useful to answer this question.
QUESTION 3
Refer to the exhibit.
Multicast MOH needs to be run from flash at the remote site. Which Cisco IOS configuration at the SRST router is correct?
A. !
call-manager-fallback
ip source-address 10.1.5.102 port 2000
max-ephones 2
max-dn 8 dual-line
moh music-on-hold.au
multicast moh 239.1.1.1 port 16384
B. !
call-manager-fallback
ip source-address 10.1.5.102 port 2000
max-ephones 2
max-dn 8 dual-line
moh music-on-hold au
multicast moh 239.1.1.1 port 163t
C. call-manager-fallback
ip source-address 10.1.120.1 port 2000 max-ephones 2 max-dn 8
moh music-on-hold.au
multicast moh 239.1.1.1 port 32767
D. !
call-manager-fallback
ip source-address 10.1.5.102 port 2000
max-ephones 2
max-dn 8 dual-line
moh music-on-hold an
multicast moh 239.1.1.1 port 32767
E. B, C, D
Answer: A
Explanation:
Ok, port 16384 , 101.5.102 , extention file .au (Be Aware to the DOT !!!! Verify the presence of music-on-hold.au)
see 3-25 and 3-28 CIPT2
